1947 Business Coupe Fat Fender Hot Rod This is a business coupe which is rare for 1947 so there was no back seat when it was built, this one has small one. Camaro front clip, power steering, Front disk brakes Hydro Boost master cylinder All new brake components and parts 355 HP ZZ4 GM performance crate motor with less than Bowtie overdrives built 700R4 automatic (K case), built for 600 hp, with 4:11 Posi-Traction reads gears, Dana rear-end (will smoke tire) combination almost bullet proof. Carbon fiber leaf springs Vintage Air blows cold + heat system Custom 3 pass aluminum radiator Custom hood hinges flip hood forward Custom Aluminum gas tank 11,000 miles since all new components installed. ZZ4 Crate motor With over 405 ft.-lbs. of torque, aluminum head, 4-bolt main block, roller cam, The aluminum angle-plug cylinder heads have screw-in rocker studs, 1.94 in. intake and 1.50 in. exhaust valves, and 58cc combustion chambers 10:1 compression ratio, lightweight valve spring retainers, radiused valve seats, and valve stem seals, billet steel hydraulic roller tappet camshaft with a .474 in. intake and .510 in. exhaust valve lift. Paint and Body are driver level with older Dark Burgundy paint that still has a nice clear coat on it. It will polish up very nice with right compound and wheel. There are some areas of paint cracking and chips on lower corners and fenders. Body is straight and lines are good, doors open and close just like they should. No rust, No rust bubbles. Paint has scratches, touch ups, chips, defect however it’s nice enough to turn heads at cruise night. Exterior chrome bumpers, moldings and emblems are in very nice condition. Interior features bucket seats, arm rest with center console. Additional features include: * 15” inch Chrome moon style wheels with stagger tires * HEI distributor. * Dual-plane aluminum intake manifold * Holley 770 cfm carburetor * 8 in. harmonic balancer * 12.75 in. automatic transmission flexplate.